Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
CAUTION
1.
Parts of the nozzle supplied are sharp, so use
gloves when removing them from the case and
when attaching or detaching them.
2.
The hot wind release nozzle, the tip of the nozzle
and the material that was heated are extremely
hot during and immediately after using the tool,
so use gloves and avoid touching them directly.
3.
Do not use inside boxes, drawers or other enclosed
spaces.
Aiming it constantly at a single location may result
in the outbreak of smoke or fire.
4.
Make sure the nozzle is at least 5cm away from
the item being heated when using the tool. Also,
do not cover or otherwise block the nozzle.
Failure to observe this may result in the Heat Gun
overheating, leading to malfunctions.
5.
Do not switch the tool on and off repeatedly. Also,
do not use the tool with the power cord folded or
twisted.
Failure to observe this may result in malfunctions.
6.
Do not point the heat-wind release nozzle
downwards immediately after use.
Failure to observe this may result in the tool
overheating, leading to malfunctions.
7.
Make sure that the Heat Gun has cooled completely
before storing it away.
Failure to observe this may result in burns or
malformation of the storage case.
8.
Definitions for symbols used on this tool
V .............................. volts
Hz ............................ hertz
A .............................. amperes
W ............................. watt
............................. Class II Construction
---/min ..................... revolutions or reciprocation
............................. Alternating current
MAKE THEM AVAILABLE TO OTHER USERS
6
per minute
SAVE THESE INSTRUCTIONS
OWNERS OF THIS TOOL!
DOUBLE INSULATION FOR SAFER
OPERATION
To ensure safer operation of this power tool, HITACHI
has adopted a double insulation design. "Double
insulation" means that two physically separated
insulation systems have been used to insulate the
electrically conductive materials connected to the power
supply from the outer frame handled by the operator.
Therefore, either the symbol " " or the words "Double
insulation" appear on the power tool or on the nameplate.
Although this system has no external grounding, you
must still follow the normal electrical safety precautions
given in this Instruction Manual, including not using the
power tool in wet environments.
To keep the double insulation system effective, follow
these precautions:
Only HITACHI AUTHORIZED SERVICE CENTER
should disassemble or assemble this power tool,
and only genuine HITACHI replacement parts
should be installed.
Clean the exterior of the power tool only with a
soft cloth moistened with soapy water, and dry
thoroughly.
Never use solvents, gasoline or thinners on plastic
components; otherwise the plastic may dissolve.
AND
AND
Tabla de contenido
