Idiomas disponibles
Idiomas disponibles
How to Stop Your Pressure Washer
1. Let engine idle for two minutes.
2. Move throttle lever on engine to "Stop" position.
3. ALWAYS point gun in a safe direction and
squeeze spray gun trigger to release retained high
water pressure.
IMPORTANT: Spray gun traps high water pressure,
even when engine is stopped and water is disconnected.
WARNING
The high pressure stream of water that this
equipment produces can pierce skin and its
underlying tissues, leading to serious injury
and possible amputation.
Spray gun traps high water pressure, even
when engine is stopped and water is
disconnected, which can cause injury.
• Keep high pressure hose connected to pump and spray
gun while system is pressurized.
• ALWAYS point gun in safe direction and squeeze spray
gun trigger, to release high pressure, every time you stop
engine. Engage trigger lock when not in use.
4. Engage trigger lock on spray gun when not in use.
How to Use Accessory Tray
The unit is equipped with an accessory tray with
places to store your nozzle extension, spray gun,
turbo nozzle, and ProjectPro™ nozzles. There is also
a hook at the front of the accessory tray to hold your
high pressure hose.
NOTE: The extra hole in the tray is for storing a utility
brush. The brush is NOT included with your pressure
washer. You can buy the brush as an optional accessory.
1. Place nozzle extension through hole on accessory
tray, as shown.
Typical Pressure
Washer Shown
2. Place spray gun through hole on accessory tray
on right side of unit.
3. Push turbo nozzle up and into clip on accessory
tray until it snaps in as shown.
4. Hang high pressure hose on hook attached to
accessory tray on front of tray as shown.
5. Insert multi–colored ProjectPro™ nozzles in
spaces provided in accessory tray.
How to Use ProjectPro™ Nozzle System
The quick–connect on the nozzle extension allows you
to switch between four different ProjectPro™ system
nozzles. The ProjectPro™ nozzles vary the spray
pressure and pattern as shown.
High Pressure
Delicate
40° Yellow
1650 PSI
2.2 GPM
Follow these instructions to change ProjectPro™
nozzles:
1. Engage trigger lock on spray gun.
A pressure washer produces a high pressure spray
which increases risk of injury and damage to unit.
• NEVER exchange ProjectPro™ nozzles without
engaging the trigger lock on the spray gun.
• DO NOT twist ProjectPro™ nozzles while spraying.
2. Pull back collar on quick–connect and pull current
ProjectPro™ nozzle off. Store ProjectPro™
nozzles in holder provided on the accessory tray.
3. Select desired ProjectPro™ nozzle:
•
For delicate rinse (lower pressure and higher
flow), for gentle cleaning of cars/trucks, boats,
RV's, patio furniture, lawn equipment, etc.,
select yellow Delicate ProjectPro™ nozzle.
11
Low
Pressure
Black
Use to apply
detergent
Max
General
0° Red
15° Orange
2200 PSI
1950 PSI
1.9 GPM
2.1 GPM
CAUTION
