Parkside PLPRS 1,5 B4 Instrucciones De Uso página 14

Smoothing (Fig. F)
♦ Allow the hard wax to cool for a few seconds
(about 10 seconds).
♦ After cooling, smooth any protrusion with the
planing grooves of the scraper
light pressure to smooth the protrusion.
Fine matching (Fig. G)
♦ For fine matching, now imitate the grain struc-
ture with a darker colour tone.
♦ Subsequently, again smooth any protrusion
with the planing grooves of the scraper
Degreasing (Fig. H)
♦ To finish, remove the last hard wax residues
with the sanding sponge
gloss level of the surface will also be simulta-
neously matched. Job done!
Cleaning the planer grooves (Fig. I)
♦ Place the cleaning scraper
grooves of the scraper
residues from the plane grooves.
Troubleshooting
In this chapter you will receive important informa-
tion for malfunction localisation and malfunction
remedies.
Malfunction causes and remedies
The following table will help with localising and
remedying minor malfunctions:
Defect
The wax melter
tip does not
get hot.
NOTICE
► If you cannot solve the problem with the
aforementioned solutions, please contact the
Service Hotline (see chapter Service) .
│ GB │ IE
■ 10
and scrape the wax
Possible
cause
The batteries
have been
inserted
incorrectly.
The batteries
are dischar-
ged.
. Use only
. Thereby the
on the plane
Solution
Insert the
batteries into
the wax melter
as indicated
in the battery
compartment
.
Insert two new
batteries.
PLPRS 1,5 B4
.