Hitachi Koki C 10FSHC Instrucciones De Seguridad Y Manual De Instrucciones página 29

CAUTION:
WARNING:
4. Cutting wide workpieces (Slide cutting)
1
Pull forward
3 Push backward
Fig. 27
Increased pressure on the handle will not increase the cutting
speed.
On the contrary, too much pressure may result in overload of the
motor and/or decreased cutting effi ciency.
* Confi rm that the trigger switch is turned OFF and the power plug
has been removed from the receptacle whenever the tool is not
in use.
* Always turn the power off and let the saw blade stop completely
before raising the handle from the workpiece.
If the handle is raised while the saw blade is still rotating, the cut-
off piece may become jammed against the saw blade causing
fragments to scatter about dangerously.
* Every time one cutting or deep-cutting operation is fi nished,
turn the trigger switch off , and check that the saw blade has
stopped. Then raise the handle, and return it to the full retract
position.
* Be absolutely sure to remove the cut material from the top of the
turntable, and then proceed to the next step.
* Continued cutting operation can result in overload of the motor.
Touch the motor and if it's hot, stop your cutting operation at
once and rest for 10 minutes or so, and then restart your cutting
operation.
Handle
2
Press down
Workpiece
(1) Workpieces up to 3-1/2" (89 mm) high and
11-1/2" (292 mm) wide:
Loosen the slide securing knob (see
Fig. 1), grip the handle and slide the saw
blade forward.
Then press down on the handle and
slide the saw blade backward to cut the
workpiece as indicated in Fig. 27. This
facilitates cutting of workpieces of up
to 3-1/2" (89 mm) in height and 11-1/2"
(292 mm) in width.
(2) Workpieces up to 2-1/2" (64 mm) high and
12-1/2" (318 mm) wide:
Workpieces of up to 2-1/2" (64 mm) in
height and up to 12-1/2" (318 mm) in
width can be cut in the same manner as
described in paragraph 4-(1) above on
page 29.
English
29