Tabla de contenido
Idiomas disponibles
Idiomas disponibles
F.M8*11PCS
B.M8*45*2PCS
C.M8*20*6PCS
Step 1：
A.Open the front and rear supports holder (1) of the inversion machine, and insert the
pull-ring pin (G) into the hole at the connection between the front and rear supports
holder.
B.Adjust the appropriate fitness angle, insert the backplane (2) into the holes on both
sides of the rear support as required (the side with the punched hole is fully in place,
and the other end with the hook is clamped above the square tube to fix it) or not
inserted (In this way, you can stand upside down completely. It is recommended that
you install it in the top hole first, and then adjust it to other holes or not install it when
you are used to it.) (Note: when starting to assemble, do not lock all the screws)
A.M8*55*4PCS
I.M5*1PCS
J.1PCS
H.M8*12*1PCS
G.M8*55*3PCS
E.M8*13PCS
D.M6*15*6PCS
29
Tabla de contenido
