Idiomas disponibles
Idiomas disponibles
aspects of this design have been examined to ensure the most faithful
music reproduction.
The main functions of the RAS-5000 are easy to install and use. If you
have experience with other stereo systems, you shouldn't find anything
perplexing. Simply plug in the associated components and enjoy.
A Few Precautions
WARNING: To avoid potential damage to your system, turn off ALL
the components in the system when connecting or disconnecting
the loudspeakers or any associated components. Do not turn the
system components back on until you are sure all the connections
are correct and secure. Pay particular attention to the speaker wires.
There must be no loose strands that could contact the other speaker
wires, or the chassis of the unit.
Please read this manual carefully. It provides information on how to
incorporate the unit into your system as well as information that will help
you get optimum sound performance. Please contact your authorized
Rotel dealer for answers to any questions you might have. In addition, all
of us at Rotel welcome your questions and comments.
Save the shipping carton and all enclosed packing material for future use.
Shipping or moving the unit in anything other than the original packing
material may result in severe damage to your unit.
If included in the box please complete the owner's registration card or
register on line. Also be sure to keep the original sales receipt. It is your
best record of the date of purchase, which you will need in the event
warranty service is ever required.
Placement
Like all audio components that handle low level signals, this unit can
be affected by its environment. Avoid placing the unit on top of other
components. Also avoid routing audio signal cables near power cords.
This will minimize the chance it will pick up hum or interference.
The unit generates heat as part of its normal operation. The heat sinks
and ventilation openings in the unit are designed to dissipate this heat.
The ventilation holes in the top cover must be open. There should be 10
cm (4 inches) of clearance around the chassis, and reasonable airflow
through the installation location, to prevent the unit from overheating.
RAS-5000
POWER
PHONES
Remember the weight of the unit when you select an installation location.
Make sure that the shelf or cabinet can support it. We recommend
installing the unit in furniture designed to house audio components.
Such furniture is designed to reduce or suppress vibration which can
MENU
ENTER
STREAMING
USB
PC-USB
AUX
BT
COAX
OPT
adversely affect sound quality. Ask your authorized Rotel dealer for advice
about component furniture and proper installation of audio components.
Cables
Be sure to keep the power cords, digital signal cables and analog
audio signal cables in your installation away from each other. This will
minimize the chance of the analog audio signal cables picking up noise
or interference from the power cords or digital cables. Using only high
quality, shielded cables will also help to prevent noise or interference from
degrading the sound quality of your system. If you have any questions
see your authorized Rotel dealer for advice about the best cable to use
with your system.
The Remote Control
Some functions can be done with either the front panel controls, or the
supplied the remote control. When these operations are described, the
square call out numbers refer to the main unit, while the encircled letters
refer to the remote control.
Remote Control Batteries
To change the battery of the remote control, first remove the two screws
shown as figure 1. Then remove the battery holder by pulling it downwards.
Insert a new CR 2035 battery into the battery holder according to the
marking (+ on the battery facing downwards). Now insert the holder as
shown and use two screws to fasten the holder.
NOTE: Use only the tool supplied with the unit to remove the screw
to avoid damage to the hex screw.
NOTE: Do NOT over-tighten the screw to avoid damage to the screw
or remote control.
Figure 1
11
