Idiomas disponibles
Idiomas disponibles
Cutters
Depth Gauge
Drive Links
Place chain onto t he sprocket
7. Place chain over and behind
clutch, fit-
ting the drive l inks i nthe clutch drum
sprocket.
8. Fit b ottom o fdrive l inks b etween
the
teeth i nthe sprocket
inthe nose ofthe
guide bar.
9. Fit c hain drive links i nto b ar g roove.
10. P ull guide bar forward
until chain issnug
inguide bar g roove. Ensure aN drive
links are inthe bar groove.
NOTE:
CHAIN
BRAKE
MUST
BE
DISENGAGED
BEFORE
INSTALLA-
TION
ON THE SAW.
TO DISENGAGE
CHAIN
BRAKE,
PULL
THE
FRONT
HAND
GUARD
BACK
TOWARD
THE
REAR
OF
THE
CHAIN
BRAKE
AS
FAR AS POSSIBLE
(SEE
ILLUSTRA-
TION).
DISENGAGED
_
GAGED
/
11. Now, installchain
brakemaking
surethe
adjusting
pin is positioned
in the lower
hole in the guide bar. Remember
this pin
moves the bar forward and backward
as
the screw is turned.
12. Install chain brake nuts and finger tight-
en only.
Once the chain is tensioned,
you will need to tighten chain brake nuts.
CHAIN
TENSION
(including
units with chain already
h_staNed)
NOTE:
When
adjusting
chain
tension,
make
sure the chain brake nuts are finger
tight only.
Attempting
to tension
the chain
when
the chain
brake
nuts are tight
can
cause damage.
Checking
the tension:
Use the screwdriver
end of the chain adjust-
ment toot (bar tool) to move the chain around
the bar. If the chain does net rotate, it is too
tight. Iftoo loose, the chain will sag below the
bar.
Chain Adjustment
Chain Brake Nuts
Tool (Bar Toot)
Adjusting
the tension:
Chah_ tension
is very
h_qportant.
Chain
stretches
during use. This is especially
true
during the first few times you use your saw.
Always
check
chain tension
each time you
use and refuel your saw.
You can adjust the chain tension
by loosen-
ing the chain brake nuts and turning the ad-
justing screw
1/4 of a turn while lifting up on
the bar.
• If chain is too tight, turn adjusting screw 1/4
turn counterclockwise>
• If chain is too loose, turn adjusting
screw
1/4 turn clockwise.
,--Z:Z_ZD--/o/Adjust,
ng /
/
"_
I_
Screw
"f
J
Chain Brake Nuts
Guide Bar
Adjusting
Screw
- 1/4 Turn
• Lift up the tip of the bar and tighten the
chain brake nuts with the bar tool.
• Recheck
chain tension.
Chain Brake
_IWARNING:
If the saw is operated
with a loose chain, the chain could jump off
the guide bar and result in serious
injury.
