Idiomas disponibles
Idiomas disponibles
3. Proper use
The equipment is designed for infl ating tires with
compressed air and for showing and adjusting tire
pressure.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
Working pressure: .................................. 0-13 bar
Display mode: ................... PSI, bar, MPa, kg/cm²
Battery: ......... Two CR2032 batteries (3V, 0.2 Ah)
5. Before starting the equipment
5.1 Quick-release coupling
Connect
Push the nipple on your compressed air hose into
the quick-release coupling, the sleeve will auto-
matically spring forwards.
Disconnect
Pull back the sleeve and remove the hose.
Warning! As you release the hose coupling,
hold the hose coupling part in your hand to
prevent injuries caused by the hose being
thrown backwards.
The compressed air hose is also fi tted with a
quicklock coupling to which accessories can be
connected as described above.
Anl_DL-Set_15tlg_m_T_SPK13.indb 12
Anl_DL-Set_15tlg_m_T_SPK13.indb 12
GB
6. Operation
Danger! Fit the adapters (3, 4, 5) fully onto the
connector (6), otherwise there is a risk of them
being thrown off during use (Fig. 3-5).
For information on the correct use of the adapters
for the various valves, please refer to the following
overview:
•
Ball needle (Figure 1)
Uses: For pumping up balls.
The ball needle can be used to pump up various
types of balls.
TIP: To avoid damaging the valve, moisten the
ball needle slightly before inserting.
•
Valve adapter (Figure 2)
Uses: Fits bicycle tyre valves.
The valve adapter makes infl ating bicycle tyres
easy.
•
Adapter 3 (Figure 3)
Uses: For all valves with an internal diameter of
over 8 mm.
You can use this adapter for the Splash-Pool or
Boat, for example.
TIP: When inserting the adapter, ensure that the
opening of the adapter is towards the open side
of the non-return valve (see diagram). This will
ensure that any problems which may arise can be
avoided.
Important! The valve cap must be opened
slightly by squezing it.
•
Adapter 4 (Figure 4)
Uses: For screw valves.
This adapter can be used for all ordinary infl ata-
ble dinghies, such as the Boat, kayaks or other
large infl atables such as pools, which are fi tted
with a screw valve.
•
Vent adapter (Figure 5)
Uses: For defl ation valves
Defl ation valves are often found with other valves
(standard valves, screw valves...) on many large
volume infl atables, such as the Flock Bed.
TIP: The infl atable can initially be infl ated using
the defl ation valve. However, you should fi nish in-
fl ating the item using the infl ation valve provided.
Adapter 3 or 4 can be used for the infl ation valve.
- 12 -
24.10.2023 13:05:04
24.10.2023 13:05:04
