Machine Operation
GB
Break-away Floor Tool
Allowing it to safely disengage from its mounting should it become caught on an obstruction, during forward machine movement.
To re-attach the blade to its holder. First loosen the retaining knobs on the floor tool body and slide onto the holding bracket.
Tighten retaining knobs to finger tight.
!
Insert the isolator key into the rear of the machine and turn to
the on '1' position.
Switch on the Vacuum (C) and the water pump (D).
To operate the machine squeeze lever (A), then press yellow
lever (B).
Releasing the Levers (A) will stop the machine.
TBL4055T
F
E
A
This machine is fitted with an Anti Crush Switch (H). Instantly stopping and moving the machine forward if accidentally reversed
into the operator.
After re-setting this switch, to restart the machine, turn the isolator key at the rear of the machine to '0' and then position '1'.
The waste water is then retrieved by the suction floor tool.
Overlap each scrubbing path by 10cm to ensure an even clean.
Do not operate on cleaning surfaces having a gradient exceeding that marked on the machine, when full.
On heavily soiled floors use a 'double scrub' technique.
First pre-scrub the floor with the floor tool in the raised position, allow the chemical time to work then scrub the area a second time
with the floor tool lowered.
If streaking occurs wipe floor tool blades clean.
Note: Care must be taken to reduce speed when cornering or when manoeuvring around obstacles
The floor tool design incorporates a break-away feature.
ALWAYS ENSURE THAT THE FLOOR IS PRE-SWEPT
AND RELEVANT SAFETY SIGNS ARE DISPLAYED.
C
D
G
B
E
H
TBL4045
TBL4055
A
TBL4055T models only set direction of travel (F) and the
desired traction speed as required (G), depending on floor type and
level of soiling. Middle speed is the optimum cleaning speed.
Switch on the Vacuum (C) and the water pump (D).
To operate the machine squeeze levers (A), then press yellow lever (B).
Releasing the Levers (A) will stop the machine.
Speed can be increased using the Speed Boost Levers (E).
The TBL4055T is equipped with an electronic braking system.
Simply release the hand operated start / stop trigger and the machine
A
will stop.
46
C
D
B
A
!
