Idiomas disponibles
Idiomas disponibles
Professional True RMS Digital Multimeter with OLED display / English
5. International Safety Symbols
Potential danger. Indicates the user must refer to the manual for important
safety information.
Indicates hazardous voltages may be present.
Equipment is protected by double or reinforced insulation.
Indicates the terminal(s) so marked must not be connected to a circuit where the
MAX
1000V
voltage with respect to earth ground exceeds the maximum safety rating of the
meter.
6. Safety Category Ratings
Category Rating
Brief Description
Single phase
receptacles and
CAT II
connected loads
Three phase circuits
and single phase
CAT III
lighting circuits in
commercial buildings
Connection point to
utility power and
CAT IV
outdoor conductors
The measurement category (CAT) rating and voltage rating is determined by a combination of
the meter, test probes and any accessories connected to the meter and test probes.
6
Typical Applications
Household appliances, power tools
Outlets more than 30ft (10m) from a Cat III
source
Outlets more than 60ft (20m) from a Cat IV
source
Equipment in fixed installations such as 3-phase
motors, switchgear and distribution panels
Lighting circuits in commercial buildings
Feeder lines in industrial plants
Any device or branch circuit that is
close to a Cat III source
Primary distribution panels
Overhead or underground lines to detached
buildings
Incoming service entrance from utility
Outdoor pumps
Professional True RMS Digital Multimeter with OLED display / English
7. Maintenance
This Multimeter is designed to provide years of dependable service, if the following
care instructions are performed:
1. KEEP THE METER DRY. If it gets wet, wipe it off.
2. USE AND STORE THE METER IN NORMAL TEMPERATURES.
Temperature extremes can shorten the life of the electronic parts and distort or melt
plastic parts.
3. HANDLE THE METER GENTLY AND CAREFULLY.
Dropping it can damage the electronic parts or the case.
4. KEEP THE METER CLEAN.
Wipe the case occasionally with a damp cloth.
DO NOT use chemicals, cleaning solvents, or detergents.
5. USE ONLY FRESH BATTERIES OF THE RECOMMENDED SIZE AND TYPE.
Remove old or weak batteries so they do not leak and damage the unit.
6. IF THE METER IS TO BE STORED FOR A LONG PERIOD OF TIME, the batteries should
be removed to prevent damage to the unit.
8. Meter Description
1. OLED display
2. RANGE/- button
3. PEAK/+ button
4. REL/
/LOG/VIEW button
5. MAX/MIN/AVG/
button
6. MODE/Bluetooth button
7. Hold/Backlight button
SET button (setting time and date)
8. Rotary Function Switch
9. 10A input jack
10. V/Ω/ CAP/DIODE/TEMP/External/
sensor input 3000A input jack
11. µA/mA input jack
12. COM input jack
13. Battery and back cover
1
r
P
o
Q
o
P
o
R
a
O
o
U
a
O
o
a
o
P
r
Q
2
3
5
4
6
7
4 4
8
9
10
11
12
13
7
