Tabla de contenido
8. Place righthand ontheleftsideoftheseatand
slowly lower thehood assembly u ntitl f ullyclosed.
NOTE:
Do not place your hand around
the bottom
edge of the hood assembly; it may get pinched between
the hood assembly and grass catcher or the frame rail.
Attaching Side-Discharge
Chute
_k
WARNING:
Battery posts, terminals and
related accessories contain lead and lead
compounds. Wash hands after handling.
Your riding mower is shipped to you with the grass
catcher fully assembled on the unit. A side-discharge
chute and a mulching plug are included as loose parts.
Follow the instructions below to attach the side-
discharge chute.
WARNING:
Do not operate the mower if any
one or more of the grass catcher, discharge
chute or mulching plug is not firmly installed on
the mower.
1.
Pivot the hood assembly up and lower the cutting
height adjustment lever to the lowest position.
2.
Remove the two wing nuts (A and B in Figure 4 )
from two ends of the grasscatcher chute.
3.
Slide the grasscatcher chute to the right and out of
the deck frame. Slide the side-discharge chute in
and place it on the deck so that the two wing nut
positions align with those on the deck.
4.
Reinsert wing nuts A and B and tighten.
Grass Catcher Chute_
Attaching Mulch Plug
While operating your riding mower, you have three
options: (i) to collect grass clippings in the grass
catcher, (ii) to discharge grass clippings on the side, or
(iii) to mulch grass and recirculate clippings back to the
lawn. For the third option, attach the mulching plug to
the side-discharge chute and then to the deck.
1.
Put two hex bolts through the mulching plug at the
respective openings. See Figure 5.
2.
Place speed nuts over the hex bolts.
Nut
jSide
Discharge Chute
Wing
A
Hex Bo_
_
Plug
Figure 5
3.
Insert the plug into the side-discharge chute
aligning the two slots on two sides of the side-
discharge chute with those on the mulching plug.
4.
To attach the mulching plug now to the unit, follow
instructionson previous page to attach side-
discharge chute to the deck.
5.
Place wing nut on each of the hex bolts and thread
a few turns. See Figure 5. Check that the mulch
plug is aligned correctly within the discharge chute.
6.
Tighten both wing nuts.
Discharge
ring Nut B
Wing Nut A"
Figure 4
Tabla de contenido
