Tabla de contenido
If the machine is to be inoperative for a period longer
than 30 days, prepare for storage as follows.
Battery
1.
Charge battery fully. The battery loses some of its
charge each day when the unit is not used. NEVER
store battery without a full charge. Recharge
battery before returning to service or every two
months, whichever occurs first.
2.
When storing unit for extended periods, disconnect
battery cables and remove the battery from the unit.
3.
Clean dirt and chaff from cylinder, cylinder head
fins, blower housing, rotating screen and muffler.
Engine
Engines, stored over 30 days, need special attention to
prevent gum formation in the fuel system or on the
carburetor.
1.
If fuel tank contains oxygenated or reformulated
gasoline, that is gasoline blended with alcohol or
ether, run engine until dry.
2.
If fuel tank contains gasoline, either run engine till
dry or add an additive to the gas. If you are using
additive, run the engine for several minutes to
circulate the additive through the carburetor.
3.
Change oil on a warm engine.
4.
Remove spark plug and pour about one ounce of
engine oil into cylinder. Replace the spark plug and
crank engine slowly to distribute the oil.
5.
Clean engine of debris, chaff or grass clippings.
6.
Store engine and riding mower in a clean, dry area
far away from stove, furnace, water heater or
similar appliances using a pilot light or any other
sparking device.
Riding Mower
1.
Clean the engine and the entire unit thoroughly.
2.
Lubricate all pivot points. Wipe the entire machine
with an oiled rag to protect the surfaces.
3.
Store unit in a clean, dry area. Do not store next to
corrosive materials, such as fertilizer.
4.
When storing any type of power equipment in an
unventilated or metal storage shed, care should be
taken to rustproof the equipment. Using a light oil or
silicone, coat the equipment, especially any chains,
springs, bearings and cables.
Trouble
Excessivevibration
Mower will not
discharge grass or
leaves uncut strips
Broken Belt
t.
Possible Cause
Bent or damaged blade
2.
Bent blade.
1.
Engine speed low.
2.
Speed selection.
3.
Cutting height set too low.
4.
Blades short or dull.
1.
Sudden stop or shock load to belt
2.
Incorrect belt used
3.
Belt engaged abruptly
4.
Defective or damaged belt
Remedial Action
1.
Stop engine immediately. Check all
pulleys, blade adapters, keys and bolts for
tightness and spindle damage. Tighten or
replace any damaged parts.
2.
Stop engine immediately. Replace
damaged blade. Only use original
equipment blades.
1.
Throttle must be set at full throttle.
2.
Use lower ground speed. Slower the
ground speed, better the quality of cut.
3.
Raise the deck.
4.
Sharpen or replace blades (uncut strip
problem only).
1.
Inspect rider for cause such as foreign
objects stuck in between deck and frame or
belt path. Remove obstruction and check
for damage. Replace belt if needed.
2.
Replace with proper belt. Check Parts list
in this manual for correct part number.
3.
Engage belt slowly by depressing the
blade engagement pedal slowly.
4.
Replace with proper belt. Follow
instructions on page 18.
23
Tabla de contenido
