Idiomas disponibles
Idiomas disponibles
.
Insert spray gun holder wireform (A) through hole just
above cleaning tank on left side of handle (viewing from
front of unit). Hold wimform in place and attach a piastic
knob (B) from inside of unit. Tighten by hand.
l
Attach Detergent Siphon Hose to Pump
The pressure washer is equipped with two detergent
siphoning hoses. One is attached to the cleaning tank and
one is loose for siphoning pressure washer safe detergents
from a bottle or container.
Attach one of the detergent siphon hoses (A) to the barbed
hose fitting (B) on the pump.
IMPORTANT:Only one detergent siphoning hose can be used
at a time. When cteaning tank is not used, make sure
detergent shut=off valve oll cleaning tank is in the "Off"
position.
Add Engine Oil
1.
Place pressure washer on a fiat, bvei surface.
2.
Cleanarea around oil fill and remove yellow oil fill
cap/dipstick.
NOTE:See Oi/Recommendations in Ma,_otenance s ection.
Verify provided oii bottle is the correct viscosity for current
ambient temperature.
3.
Using oii funne! (optional), sIowiy pour contents of
provided oil bottle into oil fill opening.
improper treatment of pressure washer can damage it and
shorten its iife.
DONOT attemptto crankor stat the enginebeforeit hasbeen
properlyservicedwith the recommended o il. This may resultin
an enginefailure.
4.
Replace oil fill cap/dipstick and fully tighten.
Add Fuel
Fuel must meet these requirements:
.
Clean,fresh, unleaded gasoline.
o
A minimum of 87 octane/87 AKi (91 RON). High altitude
use, see High A/titude.
.
Gasoiinewith up to 10% ethanoi (gas@@ or up to 15%
MTBE (methyl tertiary butyl ether) is acceptable.
Avoid pressure washer damage.
Failureto follow Operator's Manual for fuei
recommendations voids warranty.
DONOTuseunapproved gasolinesuchas E85.
DONOTmix oil in gasoline.
DONOTmodifyengineto run on alternate fuels.
To protect the fuel system from gum formation, mix in a fuel
stabiiizer when adding fueI. See Storage. Ali fuei is not the
same. if you experience starting or performance probiems
after using fuel, switch to a different fuel provider or change
brands. This engine is certified to operate on gasoline. The
emission control system for this engine is EM (Engine
Modifbations).
WARNING
Fueland its vapors are extremely flammable and
explosive.
Fire or explosion can cause severe burns or
death.
WNENADDINOFNEL
o Turnpressure washerOFF and let it coolat least2 minutes
beforeremovingfuelcap. Loosencapslowlyto relievepressure
in tank.
o Fillfuel tankoutdoors.
• DONOToverfilltank.Allowspacefor fue! expansion.
o If fuel spills wait until it evaporates beforestartingengine.
• Keepfuelawayfrornsparks,openflames,pilot lights,heat,and
otherignitionsources.
DONOTlight a cigaretteor smoke.
Cleanarea around fuet fill cap, remove cap.
Siowiy add regular unleaded fuel (A) to fuet tank (B). Be
carefui not to overfiii. Aliow about 1.5" (4 cm) (C) of tank
space for fuel expansion.
®
1.
2.
3.
Install fuel cap and wait for any spilled fuel to evaporate.
