Idiomas disponibles
Idiomas disponibles
Your c leaning system requires some assembIy andisready
foruse onlyafter i t hasbeen properiy serviced withthe
recommended
oilandfuel.
Jf
you have any prohbms with the assembly of your
pressurewasher, please call the pressurewasher hempline
at 1o800o222o3136.
UNPACKTHE PRESSURE WASHER
1.
Remove everything from carton except pressure washer.
2.
Open carton completely by cutting each corner from top
to bottom.
3.
Remove pressure washer from carton.
CARTONCONTENTS
Checkali contents, if any parts are missing or damaged, call
the pressure washer hetpline at 1=800=222=3136.
°
Main Unit
°
Handle
,
6baning Tank Assembly
°
High Pressure Hose
°
Spray Gun
,
NozzleExtensionwith Quick Connect Fitting
*
OiI Bottle
°
DetergentSiphoning Hose/Fiiter
,
Parts Bag (which includes the following):
o
Operator's Manual
,
Owner's Registration Card
,
Safety Goggles
o
Gun Hoider Wireform
,
Bagcontaining 4 multi-colored Spray Tips
,
HandleFasteningHardwareKit (which includes):
o
Carriage Bolts (2)
°
"U' Bott
°
Plastic Knobs (4)
°
Tree Clips (4)
Becomefamiiiar with each piece before assembling the
pressure washer. Identify ati contents with the iiiustration on
page 6. if any parts are missing or damaged, call the
pressure washer hetpline at 1=800=222=3136.
ASSEMBLINGCLEANING SYSTEM
Your Craftsman
cJeaning system
wJJJ need assembJy
before
operation:
1.
Fiii out and send in registration card.
2.
Attach handle and cleaning tank.
3.
Connect detergent siphon hose to pump.
4.
Add oii to engine crankcase.
5.
Add fuel to fuet tank.
6.
Connect pressure hose to spray gun and pump.
7.
Connect water supply to pump.
8.
Attach nozzleextension to spray gun.
9.
Select/attach quick connect spray tip to nozzle extension.
Attach Handle and Cleaning Tank
1.
Placehandle (A) onto handb supports (B) connected to
main unit. Make sure holes (C) in handle align with hobs
(C) on handle supports.
NOTE:it may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handb supports.
2.
Insert carriage bolts (A) througil holes from back of unit
and attach a plastic knob (B) from front of unit. Tigilten
by hand.
Placecleaning tank (B) over holes (C) on handb
(viewing from front of unit). Push the tree clips (A) into
the holes until they sit fiat against the cleaning tank.
i
/
/
z/
Insert "L" bolt (A) through hole just abovecleaning tank
on right side of handle (viewing from front of unit). Hold
bolt in piace and attach plastic knob (B) from inside of
unit. Tighten by hand.
