Fuse Replacement - Ibiza Light MH-ASTRO-LASER-WASH Manual De Uso

MANUAL - MH-ASTRO-LASER-WASH
• The unit must be installed in a location with adequate ventilation, at least 20in (50cm) from adjacent surfaces.
Be sure that no ventilation slots are blocked.
• Always disconnect from power source before servicing or replacing fuse and be sure to replace with same fuse
size and type.
• Secure fixture to fastening device using a safety chain. Never carry the fixture solely by its head. Use its carry-
ing handles.
• Maximum ambient temperature (Ta) is 104° F (40°C). Do not operate the fixture at temperatures higher than
this.
• In the event of a serious operating problem, stop using the unit immediately. Never try to repair the unit by
yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please contact the near-
est authorized technical assistance center. Always use the same type of spare parts.
• Don't connect the device to a dimmer pack.
• Make sure the power cord is never crimped or damaged.
• Never disconnect the power cord by pulling or tugging on the cord.
• Avoid direct eye exposure to the light source while it is on.
• The product is for decorative purposes only and not suitable as a household room illumination.
• The light source of this luminaire is not replaceable. When it reaches the end of its life time, the whole unit
must be discarded.
• DISCONNECT DEVICE: Where the MAINS plug or an appliance coupler is used as the disconnect device, the
disconnect device shall remain readily operable.
FEATURES
• 20/24 DMX channels
• Modes: DMX, master-slave, music-controlled, auto, static colour, colour change and gradient
• ASTRO effect with 1x 10W 4-in-1 RGBW Osram LED
• WASH effect with 36x 0.2W RGB 3-in-1 SMD LEDs
• Green 50mW LASER
• Strobe
• Dimmer
• Adjustable brightness of the RGBW LEDs of the Wash effect
INSTALLATION
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to
avoid vibration and slipping while operating. Always ensure that the structure to which you are attaching the
unit is secure and able to support a weight of 10 times of the unit's weight. Also always use a safety cable that
can hold 12 times the weight of the unit when installing the fixture.
The equipment must be fixed by professionals at a place where is out of the reach of people and where nobody
can pass by or under it.

FUSE REPLACEMENT

Disconnect the power cord before replacing a fuse and always replace with the same type fuse
• With a flat head screwdriver wedge the fuse holder out of its housing.
• Remove the damaged fuse from its holder and replace with exactly the same type of fuse.
• Insert the fuse holder back in its place and reconnect power.
• The fuse is located inside this compartment. Remove using a flat head screwdriver.
FIXTURE LINKING
You will need a serial data link to run light shows of one or more fixtures using a DMX-512 controller or to run
synchronized shows on two or more fixtures set to a master/slave operating mode. The combined number of
channels required by all fixtures on a serial data link determines the number of fixtures that the data link can
support.
Console
Light1
Important: Fixtures on a serial/data link must be daisy chained in one single line.
Light2 Light3
www.ibiza-light.com
5