Transporting; Taking Care Of Unexpected Problems; Engine Will Not Start; Engine Lacks Power - Honda GXH50 Manual Del Propietário

Storage Precautions
If your engine will be stored with gasoline in the fuel tank and
carburetor, it is important to reduce the hazard of gasoline vapor
ignition. Select a well-ventilated storage area away from any
appliance that operates with a flame, such as a furnace, water
heater, or clothes dryer. Also avoid any area with a spark-
producing electric motor, or where power tools are operated.
If possible, avoid storage areas with high humidity, because that
promotes rust and corrosion.
Keep the engine level in storage. Tilting can cause fuel or oil
leakage.
With the engine and exhaust system cool, cover the engine to
keep out dust. A hot engine and exhaust system can ignite or melt
some materials. Do not use sheet plastic as a dust cover.
A nonporous cover will trap moisture around the engine,
promoting rust and corrosion.
Removal from Storage
Check your engine as described in the BEFORE OPERATION
CHECKS section of this manual (see page ).
If the fuel was drained during storage preparation, fill the tank with
fresh gasoline. If you keep a container of gasoline for refueling, be
sure it contains only fresh gasoline. Gasoline oxidizes and
deteriorates over time, causing hard starting.
If the cylinder was coated with oil during storage preparation, the
engine will smoke briefly at startup. This is normal.

TRANSPORTING

If the engine has been running, allow it to cool for at least 15
minutes before loading the engine-powered equipment on the
transport vehicle. A hot engine and exhaust system can burn you
and can ignite some materials.
Keep the engine level when transporting to reduce the possibility
of fuel leakage. Turn the fuel valve to the OFF position (see
page 5 ).
12
3
ENGLISH

TAKING CARE OF UNEXPECTED PROBLEMS

ENGINE WILL Possible Cause
NOT START
1. Check control Fuel valve OFF.
positions.
Choke open.
Engine switch
OFF.
2. Check engine Engine oil level
oil level. low
(Oil Alert stops
engine).
3. Check fuel. Out of fuel.
Bad fuel; engine
stored without
treating or
draining
gasoline, or
refueled with
bad gasoline.
4. Remove and Spark plug faulty,
inspect spark fouled, or
plug. improperly
gapped.
Spark plug wet
with fuel
(flooded engine).
5. Take engine to Fuel filter
an authorized restricted,
Honda carburetor
servicing malfunction,
dealer, or refer ignition
to shop malfunction,
manual. valves stuck, etc.
ENGINE LACKS Possible Cause
POWER
1. Check air filter. Filter element
restricted.
2. Check fuel. Bad fuel; engine
stored without
treating or
draining
gasoline, or
refueled with
bad gasoline.
3. Take engine to Fuel filter
an authorized restricted,
carburetor
Honda
servicing malfunction,
dealer, or refer ignition
to shop malfunction,
manual. valves stuck, etc.
Correction
Move lever to ON
position.
Move lever to
CLOSED position
unless the engine
is warm.
Turn engine switch
to ON position.
Fill with the
recommended oil
to the proper level
(p. 8).
Refuel (p. 7).
Drain fuel tank and
carburetor (p. 11).
Refuel with fresh
gasoline (p. 7).
Gap or replace
spark plug (p. 9).
Dry and reinstall
spark plug. Start
engine with
throttle lever in
MAX. position.
Replace or repair
faulty components
as necessary.
Correction
Clean or replace
filter element
(p. 9).
Drain fuel tank and
carburetor (p. 11).
Refuel with fresh
gasoline (P. 7).
Replace or repair
faulty components
as necessary.