Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
No sound (The batteries of microphone have already been installed,
but one of the microphone has on sound.)
Please turn off the microphone which can work normally, and you
will find that the RF light on the receiver will disappear. Then follow the
steps below to pair the micophone (no sound) with the receiver.
1. Make sure that the receiver and microphone are turned OFF.
2. Unscrew the microphone tail tube and install the batteries into the
mic's battery compartment.
3. Make sure that the microphone is OFF, press and hold the HI/LO
button and the power button simultaneously, do not release them, until
the microphone screen flashes quickly, then release two buttons simulta-
neously.
4. Turn on the receiver's power button, wait for 5 seconds or so, then
press the HI/LO button (on the microphone) once, until the microphone
screen becomes steady and no longer flashes, the RF light on the
receiver turns steady, indicating that the pairing is successful.
5. Tum off the microphone, then tighten the microphone tail tube.
Pairing is now completed.
Received signal with noise or interference
Change to other channels.
Check if receiving distance exceeds the maximum range.
Microphone cannot be tumed on
Check if batteries are installed reversely.
Change to new batteries.
WARRANTY
TONOR provides 2 years of after-sales service, free replacement to
products that are NOT damaged resulting from accident, alteration,
misuse, negligence, or abuse. If exceeding 30 days of Amazon return
policy, you can still contact us through our Shopify TONORMIC. We will
serve you with full sincerity!
FCC Statement
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
09
