Power Down Operation - Leggett & Platt SIMPLICITY HFPS 2.0 Guia Del Usuario

Your adjustable base, depending on model purchased, may have the following feature. Use this procedure to lower
the base to flat during a power outage. Do NOT put batteries in power down device until necessary for use.
1
Insert (2) 9-volt alkaline batteries into the power brick.
POWER
BRICK
INSTALL (2) 9 VOLT
*BATTERIES NOT INCLUDED
BATTERIES (NOT INCLUDED) ARE GOOD FOR ONLY ONE USE.
2
Press the FLAT BUTTON on the remote control or in-line
switch (if equipped) to adjust the base to the level position.
ELECTRICAL
POWER CORD
PAIR
BUTTON
3
Remove batteries from power brick and discard. When power is restored
from outage, base is ready to resume normal operation.
4

POWER DOWN OPERATION

BATTERY COMPARTMENT DOOR
(push in and slide up to remove)
BATTERIES
NOTE
IN-LINE
SWITCH
PILLOW
HEAD FOOT
FLAT
FLAT
MASSAGE
REMOVE (2) 9 VOLT
BATTERIES
*BATTERIES NOT
INCLUDED