Leggett & Platt SIMPLICITY HFPS 2.0 Guia Del Usuario página 3

Simultaneously press and hold the HEAD
1
UP and FOOT DOWN buttons on the
remote control until the remote control
backlight flashes, then release.
PILLOW
HEAD
UP
HEAD FOOT
FLAT
MASSAGE
REMOTE CONTROL PROGRAMMING - 1 OR 2 REMOTES TO OPERATE 2 BASES
Plug both bases into power outlet.
1
Operate each base to verify the base
functions properly.
Lower both bases to the flat position.
Plug one end of the sync cable into the sync port (on the control box) of base 1. Plug
3
the other end of the sync cable into the sync port (on the control box) of base 2.
BASE 1 CONTROL BOX
CONTROL BOX APPEARANCE AND SYNC PORT LOCATION MAY VARY.
Operate the remote control(s) to verify both bases function correctly. If using only one
6
remote control to operate both bases, store the second remote for use as a spare.
TO REVERT BACK TO 1-TO-1 PROGRAMMING, REMOVE SYNC CABLE FROM CONTROL BOXES.
REMOTE CONTROL PROGRAMMING - 1 REMOTE TO OPERATE 1 BASE
2 Unplug the base from the power
outlet. Wait 3 minutes, then plug
base back into power outlet. YOU
HAVE 1 MINUTE TO COMPLETE
PROGRAMMING PROCEDURE.
FOOT
AN ELECTRICAL SURGE PROTECTION
DOWN
DEVICE IS RECOMMENDED (NOT INCLUDED).
NOTE
IF BASES DO NOT RESPOND, REVERT
BACK TO 1-TO-1 PROGRAMMING (SEE
SECTION ABOVE).
SYNC PORT
SYNC
CABLE
NOTE
NOTE
3 MINUTES
NOTE
UNPLUG both bases. Place both bases
2
on their sides close to each other.
DUE TO RISK OF INJURY, TWO ADULTS ARE REQUIRED
TO HANDLE AND MOVE ADJUSTABLE BASE.
BASE 2 CONTROL BOX
SYNC PORT
Simultaneously press and hold the
3
HEAD DOWN and FOOT UP buttons
on the remote control until the remote
control backlight flashes, then release.
PILLOW
HEAD FOOT
FLAT
HEAD
DOWN
MASSAGE
4
Operate the remote control to verify
the base functions correctly.
CAUTION
!
4
Turn both bases over
onto their legs.
CAUTION
!
MAKE SURE SYNC CABLE
IS NOT CAUGHT IN BASE
OR PINCH POINTS.
5
Plug both bases back
into power outlet.
NOTE
AN ELECTRICAL SURGE
PROTECTION DEVICE IS
RECOMMENDED (NOT INCLUDED).
FOOT
UP
3