Leggett & Platt FLIGHT P Guia Del Usuario página 4

REMOTE CONTROL PROGRAMMING - 1 OR 2 REMOTES TO OPERATE 2 BASES
1
Plug both bases into power outlet.
base to verify the base functions properly.
Lower both bases to the flat position.
3
Plug one end of the sync cable into the sync port (on the control box) of base 1. Plug
the other end of the sync cable into the sync port (on the control box) of base 2.
BASE 1
CONTROL
BOX
4
Turn both bases over onto their legs.
MAKE SURE SYNC CABLE IS NOT CAUGHT IN
BASE OR PINCH POINTS.
6
Operate the remote control(s) to verify both
bases function correctly. IF USING TWO REMOTE
CONTROLS, WAIT 5 SECONDS BETWEEN
OPERATING THE FIRST AND SECOND REMOTE.
If using only one remote control to operate both
bases, store the second remote for use as a spare.
TO REVERT BACK TO 1-TO-1 PROGRAMMING,
REMOVE SYNC CABLE FROM CONTROL BOXES.
4
Operate each
SYNC PORT
SYNC
CABLE
CAUTION
!
NOTE
2
UNPLUG both bases. Place
both bases on their sides close
to each other.
CAUTION
!
DUE TO RISK OF INJURY, TWO
ADULTS ARE REQUIRED TO HANDLE
AND MOVE ADJUSTABLE BASE.
BASE 2
CONTROL BOX
SYNC
CABLE
5
Plug both bases back
into power outlet.
AN ELECTRICAL SURGE
PROTECTION DEVICE IS
RECOMMENDED (NOT INCLUDED).
SYNC PORT
NOTE