Idiomas disponibles
Idiomas disponibles
0702 653 X.book Seite 11 Dienstag, 19. Oktober 2010 10:53 10
Tool Specifications
Rotary Hammer
BMH 40-XES
Demolition Ham-
mer
Article number
0702 553 X
Impact rate
1300 W
Impact energy per
stroke
2–12 J
Tool holder
SDS-Max
Drilling capacity in
concrete
- Drill bit
12–40 mm
- Core bit
40–100 mm
Optimal drilling
capacity in concrete
- Drill bit
25–35 mm
Chisel positions
18
Weight, approx
6.95 kg
Auxiliary Handle/Depth Stop
Before any work on the machine itself, pull the
mains plug.
Operate the machine only with the auxiliary
handle 11.
BMH 40-XES:
Loosen the auxiliary handle by turning the knurled
nut 12 anticlockwise.
The auxiliary handle 11 can be set to any position
for a secure and low-fatigue working posture.
The tensioning strap 3 of the auxiliary handle must
remain in the groove
Then, retighten the auxiliary handle by turning the
knurled nut 12 clockwise.
The drilling depth can be set with the depth stop 13.
For this, press the button for the depth-stop adjust-
ment 10, adjust the required drilling depth X and
release the button again.
The notched groove on depth stop 13 must face
downward
MH 5-XES:
The auxiliary handle 11 can be set to any position
for a secure and low-fatigue working posture.
Loosen the knurled nut 12, rotate the auxiliary han-
dle 7 around the axis of the machine to the required
position and tighten the knurled nut 12 again.
The auxiliary handle 11 can be mounted to a differ-
ent position. For this, completely unscrew the knurled
nut 12 and then pull out the hexagon bolt upward.
Pull off the auxiliary handle 11 to the side and turn
around the remaining clamping element by 180°.
Mount the auxiliary handle 11 in reverse order.
MH 5-XES
0702 563 X
1300 W
Before any work on the machine itself, pull the
2–12 J
mains plug.
SDS-Max
With the SDS-max tool holder, simpler and easier
tool changing is possible without additional aids.
The dust protection cap 1 largely prevents the entry
–
of drilling dust into the tool holder during operation.
–
When inserting the tool, take care that the dust pro-
tection cap 1 is not damaged.
A damaged dust protection cap should be
–
changed immediately. We recommend having
18
this carried out by an after-sales service.
6.2 kg
Inserting
Clean and lightly grease the shank end of the tool.
Insert the tool in a twisting manner into the tool
holder until it latches itself.
Check the latching by pulling the tool.
Removing
Push back the locking sleeve 2 and remove the tool.
Switching On and Off
MH 5-XES:
To switch on the machine, push the On/Off
switch 6.
To switch off the machine, press the On/Off switch
6 again
BMH 40-XES:
To switch on the machine, push the On/Off
switch 6.
To lock on the On/Off switch 6, hold the pressed
switch and additionally slide the lock-on button 7
up. The lock-on function can only be used in chisel-
ling mode. When the lock-on function is activated in
drilling mode, the power tool automatically switches
off for safety reasons.
To switch off the machine, press the On/Off
switch 6 again
Changing the Tool
Starting Operation
11
