cecotec READYWARM 2070 MAX CERAMIC ROTATE SMART Manual De Instrucciones página 34

ENGLISH
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Box content
- Heater
- Remote control
- Instruction manual
3. OPERATION
Assembly
Fig. 4
- Step 1: take the device and accessories out of the box. Assemble the two semi-circular
pieces of the base by inserting the 4 clips of one into the holes of the other.
- Step 2: with the main body upside down, install the base by inserting its 4 clips into the
holes of the main body. Then, rotate the base counterclockwise so that it stays in the
correct position.
- Step 3: to remove the base, press the locking clip by hand. After releasing the locking clip,
turn the base clockwise to remove it.
Icon functions
1. Press the power icon once to start the fan in low mode. The display will show the current
temperature. Press the icon again to turn the fan off after a 15-second countdown.
2. With the fan on, press the heating mode selector icon to toggle between Low, High and
ECO mode.
ECO Mode: the temperature will be automatically adjusted according to the ambient
temperature.
3. Press the oscillation mode activation icon to make the fan rotate from left to right in a
range of 65°. Press the icon again to stop the oscillation.
4. Use the temperature up/down icons to adjust their value within a range of 16-32°C.
- Once the temperature value has been set, the display will flash for 5 seconds. After this
time, the current room temperature value will be displayed.
- Once the room temperature reaches the set value, the device will stop working. When the
room temperature is lower than the set temperature, the appliance will switch on again.
5. Press the timer icon as many times as desired to set the operating time of the appliance
34 READYWARM 2070 MAX CERAMIC ROTATE SMART