Idiomas disponibles
Idiomas disponibles
en
ENGLISH
Battery packs with different capacities
Use only battery packs with voltage suitable for your
power tool.
2,0 Ah LiPower order no.: 625026000
4,0 Ah LiPower order no.: 625027000
5,2 Ah LiPower order no.: 625028000
4,0 Ah LiHD order no.: 625367000
5,5 Ah LiHD order no.: 625368000
8,0 Ah LiHD order no.: 625369000
10,0 Ah LiHD order no.: 625549000
etc.
For a complete range of accessories, see
www.metabo.com or the catalogue.
11. Repairs
Repairs to electrical tools must ONLY be
carried out by qualified electricians!
Only original Metabo spare parts should be used.
A defective 12V cigarette lighter connection cable
must only be replaced with a special, original 12V
cigarette lighter connection cable from Metabo,
which is available from the Metabo service.
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. For
addresses see www.metabo.com.
You can download a list of spare parts from
www.metabo.com.
12. Environmental Protection
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Packaging materials must be disposed of according
to their labelling in accordance with municipal
guidelines. Further information can be found at
www.metabo.com in the "Service" section.
Battery packs may not be disposed of with regular
waste. Return faulty or used battery packs to your
Metabo dealer!
Do not allow battery packs to come into contact with
water!
Only for EU countries: never dispose of
power tools in your household waste!
According to European Directive 2012/19/EU
on Waste from Electric and Electronic Equipment
and implementation in national law, used power
tools must be collected separately and recycled in
an environmentally-friendly manner.
Discharge the battery pack in the power tool before
disposal. Prevent the contacts from short-circuiting
(e.g. by protecting them with adhesive tape).
13. Technical specifications
Explanatory notes on the specifications on page 3.
Subject to change in accordance with technical
progress.
U
= voltage of the battery pack
A
U
= Operating voltage (via the 12V cigarette
N
lighter connection cable (21))
16
F
= Filling capacity (at 0 - 6 bar)
p
= max. pressure
max
IP
= protection class
T
= Compressor: max. storage / operating
max
temperature *
T
= Compressor: min. storage / operating
min
temperature **
T
= Battery pack: Permitted ambient
B,Akku
temperature during operation
T
= Battery pack: Permitted ambient
L, Akku
temperature during storage
m
= Weight (without battery pack)
F
= fuse (12 V)
12V
Measured values determined in conformity with
EN 62841.
Recommended ambient temperature when
charging: 0 °C to 40 °C.
direct current
The technical specifications quoted are subject to
tolerances (in compliance with relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the tool and to compare different
devices. The actual load may be higher or lower
depending on the operating conditions, the
condition of the tool or the accessories. Please
allow for breaks and periods when the load is lower
for assessment purposes. Arrange protective
measures for the user, such as organisational
measures based on the adjusted estimates.
Typical A-effective perceived sound levels:
L
= sound pressure level
pA
L
= acoustic power level
WA
L
= guaranteed acoustic power level as per
WA(G)
2000/14/EC
K
, K
=uncertainty
pA
WA
Wear ear protectors!
