Idiomas disponibles
Idiomas disponibles
Replacement
and Care of Filter
WARNING: To reduce the risk of
shock or injury from moving parts,
always unplug humidifier before
removing or replacing any parts.
CAUTION:
To help retard bacteria
growth and keep maximum efficiency,
the filter should be replaced at least
once per season, or more often
under hard water conditions+ Use
Kenmore 32-14906 recommended
replacement filter+
To replace the filter in your humidifier,
follow the instructions below+
1+ Unplug humidifier+ Before removing
the filter, we recommend moving the
humidifier to an area where floor
coverings are not susceptible to water
damage+ (i+e+kitchen or bath areas+)
2. Remove the water bottle and set aside.
Be sure not to bump or damage the
lower spring valve.
3. Grasp the housing assembly and lift
straight up and away from the base
and set aside+ The filter is now
accessible+
4+ Take note of the filter position+
Remove the filter. You may want to
clean the base at this time. See the
"Cleaning Your Humidifier" section of
this manual+
5+ Install a new filter (32-14906) into the
base. Coil the filter and position it
between the uprights in the bottom of
the base. The start and finish of the
coil should be captured at the center
of the base (see diagram) and the
filter should be resting on the floor of
the base+
Grasp housing
assembly
securemy and
lift off
f Fimter
Base Uprights
Base
