Idiomas disponibles
Idiomas disponibles
6
English
Introduction
Welcome dental professionals!
The Philips Zoom! Training Center is your destination for earning the certification required to offer Zoom! WhiteSpeed
Light Accelerated Whitening Treatments at your practice.
Visit www.zoomtraining.com to participate in a full course of 11 modules to get your office up to speed with Philips
Zoom! Whitespeed Light Accelerated Whitening Treatments (treatments).
Note: The Zoom! training course is offered in English only.
Important safety information
Do not attempt to use the Philips Zoom! WhiteSpeed Accelerator Light (accelerator light) without a thorough
understanding of these instructions for use, and the instructions for use for the Philips Zoom! Light Accelerated
Procedure Kits (procedure kits). Failure to do so may result in injury to you or your patients, or damage to the product.
Only allow trained and qualified personnel to operate the system.
Caution
- Zoom! protective eyewear must be used during operation to ensure the safety of everyone in
the treatment area. The intense light can pose hazards for the eyes. Protective safety goggles
or spectacles that filter out wavelengths between 400 and 505 nanometers (nm) must be worn
while operating this device.
- Never look directly into the light.
- Never direct the light output of the accelerator light in any direction other than the area being
treated.
- Before activating the light, confirm the accelerator light head is properly positioned and aimed
at the treatment area.
- Do not attempt to gain access to the inside of the device. Service is limited to authorized
service representatives of Philips. Any attempt to gain access to the inside of the device by
unauthorized personnel or without proper authorization is prohibited, may result in injury,
and will void any warranty or service obligations by Philips.
Electromagnetic fields (EMF) and electromagnetic compatibility (EMC)
The accelerator light complies with relevant international and national law and standards on electromagnetic
compatibility (EMC) for this type of product when used as intended. Such laws and standards define both the
permissible electromagnetic emission levels from product and its required immunity to electromagnetic interference
from external sources.
Other electronic products exceeding the limits defined in such EMC standards could, under unusual circumstances,
affect the operation of the product.
-
-
-
-
-
-
Product overview
Each accelerator light has been thoroughly inspected and tested at the factory. Upon arrival at your facility, inspect
the shipping container and the device for damage. Any damage should be reported immediately to your Philips
representative. In the case of a damaged shipment, please save all packaging materials.
ZOOM_3000.040.0114.3_BOOKLET-lux_US-letter_FC.indd 6
ZOOM_3000.040.0114.3_BOOKLET-lux_US-letter_FC.indd 6
Medical electrical products need special precautions regarding electromagnetic fields (EMF), and need to be installed
and put into service according to the EMF information provided in these instructions for use.
The use of accessories and cables other than those specified may result in increased emission or decreased
immunity levels.
The product should not be used adjacent to other products and if adjacent use is necessary, it should be observed to
verify normal operation.
To avoid the risk of electrical shock, do not remove any panels from the accelerator light.
Refer servicing to qualified personnel.
Never operate the device with a damaged power cord or plug.
07-05-21 09:39
07-05-21 09:39
