UK
WARNING:
4.4.1De-installation
If the machine must be de-installed, proceed following the inverse order for installation reported in Paragraph 4.3 - Installation.
DANGER:
To conduct the task in question, the following Individual Protection Devices are necessary:
5
.
M
a
c
h
i
n
e
U
5
.
M
a
c
h
i
n
e
U
5.1 Machine use
DANGER:
To use the machine, the following Individual Protection Devices are necessary:
5.1.1 Start-Up
Before starting-up the machine, it is necessary to make sure that:
the fastening screws are well tightened;
the electrical, water supply, and water discharge connections have been carried out correctly.
5.1.2 Switch On / Off
To turn the machine on (or off), it is necessary to keep the "ON/OFF" button located on the control panel pressed for more than 5
seconds ( (
1
in figure 9)
Once the machine has been turned on, in function of what measured by the temperature and humidity probes, and in function of
the parameters programmed on the instrument, the machine automatically performs one of the four built-in cycles of work (hot,
cold, humidification, dehumidification), depending on the particular need.
5.1.3 Use of the Management Software
The complete manual of the management software of the machine is found in Chapter 9 – Attachments.
do not remove any packaging possibly present for certain components of the machine and
take adequate precautions to protect the exposed parts.
the manufacturer declines all responsibility for any damage to property and/or persons deriving from
improper interventions conducted by unqualified, untrained or unauthorised staff.
s
e
s
e
for the machine, only operators correctly training and informed on the risks present can intervene on
the machine and only having fully read this use and maintenance handbook. the manufacturer
declines all responsibility for any damage to property and/or persons deriving from improper
interventions conducted by unqualified, untrained or unauthorised staff.
Figure 9 – Management Software.
1
WSH-WTH Pag. 48
REV. 01 04/14