Idiomas disponibles
Idiomas disponibles
ENGLISH
2. Stand in front of the front hub of the electric bike with the disc brake on the left. When
mounting the front wheel, make sure that the tyre fits. Note: If the front wheel does not
fit, the inside of the front brake calliper must be loosened.
3. Carefully stand the wheel upright and insert the fork brackets onto the fork axle. Then,
insert the front wheel fork lock washer (A1) into the front fork slot, followed by the disc
washer (A2).
4. Make sure that the wheel is correctly centred in the frame, otherwise the balance of the
electric bike may be disturbed. Make sure that the brake disc is on the left side of the
bicycle.
5. Repeat for the other side. Insert the bolts (B1) at both ends and tighten them on the shaft
by turning the 15 mm combination spanner clockwise. Finally, make sure that the wheel is
securely attached to the frame.
Assembling the pedals. Fig. 7
-
Check the marking indicating the left pedal and the right pedal. You will find stickers
indicating this. To mount the pedals, the right pedal must be screwed clockwise, and the
left pedal must be screwed counterclockwise with the 15 mm spanner.
-
In addition, the pedals can be folded down to take up less space for transport or storage.
To do this, a small force must be applied by pulling the end of the pedal upwards.
Battery substitution. Fig. 8
-
The electric bike comes with a removable battery. Remove it from the box carefully. Place
it in the gap between the rear rack and the saddle post tube. Slide it in after making sure
that the battery is correctly aligned with the vertical controller.
-
Battery key: once in place, insert the key into the hole on the right side of the battery. Turn
the key clockwise to fix the battery in its place.
-
Battery button: press the button on the front end of the battery to ensure that the power
supply is connected and functioning properly.
Charging the battery
Only use the original charger supplied to charge the electric bicycle. To start charging, insert
the charger into the socket on the side of the battery and plug it into a power source. The
battery will fully charge in 4-6 hours.
4. OPERATION
Fig. 9
The electric bicycle will start assisting with electric power once you start pedalling.
Fig. 10 key:
1.
Power button
82
FOLDING
