Idiomas disponibles
Idiomas disponibles
Step 7: Inflate tires.
Check that the tire beads and tires are evenly seated on the rims. Use a pump with a Schrader valve to
inflate each tire to the recommended pressure indicated on the tire. Do not overinflated or underinflate
tires.
BATTERY CHARGING
Charging procedure
Follow these steps for charging your ebike battery from Fafrees Bikes:
1. Ensure the battery is off.
2. Remove the rubber cover on the charging port.
3. Plug the charger into the battery ' s charging port, BEFORE PLUGGING CHARGER INTO
POWER OUTLET.
then remove the charger outlet plug from the battery charging port.
BATTERY CHARGING INFORMATION
Check the charger, charger cables, and battery for damage before beginning each charge.
Be sure to charge in an area where it is clear and safe from any potential damage or tripping situations
can occur while it is charging. Always charge your battery in temperature between 0℃– 40℃ (32℉–
104℉).
The battery can be charged on or off the bike. To remove the battery, turn the key to the unlocked
position, and take the battery out.
The battery should be recharged after each use, so it is ready to go the full range for your next ride.
There is no memory effect, so charging the battery after short ride will not cause damage.
The indicator light on the charger will show red light while the battery charges. When charging is
complete, the indicator light will turn green. Ensure the light faces upward when charging.
EN
B.Loosen the front light fixing screw on the front rack. Adjust the
head light to desired position, tighten the screw with a hex key and
a wrench.Connect the front light with the extension cable on the
front rack.
With the battery on or off the bike, place the charger in a flat,
secure place, and connect the DC output plug from the charger to
the charging port on the side of the battery.
4. Plug the charger into a power outlet: Connect the charger
input plug (110/240-volt plug) to the power outlet. Charging
should initiate and will be indicated by the LED charge status light
on the charger illuminating as red light.
5. Unplug the charger from the outlet, then the charging port:
Once fully charged, indicated by the charging indicator light
turning green, unplug the charger from the wall outlet first and
12
