Installation Specifications; Installation Precautions - Urmet 1092/252H Manual De Uso

INSTALLATION SPECIFICATIONS


Avoid pointing the lens directly towards the sun or intense sources of light also when the camera is off.
The subject must not be backlit.

Some lighting systems (e.g. coloured fluorescent lights) may false the colours.

Arrange a suitable circuit breaker and fuse upstream of the devices.

Make sure that the rating plate data correspond to the power specifications before connecting the
device to the mains.

INSTALLATION PRECAUTIONS


Though the device has an IP66 protection grade, there are particular environments (such as
seashores, harbours, wharves, etc.) that can accelerate corrosion of external parts. Also installation in
very dusty environments (quarries, mines, dusty materials, etc.) can compromise the optimal operation.

To prevent device overheating, place it in a well aired position.

For the same reason, the device must not be installed near heat sources as radiators or warm air
ducts, in places where it is directly exposed to sun irradiation or in rooms with excessive dust
accumulation, subject to mechanical vibrations or impacts.

Consider the device operating temperature range (0°C ÷ +50°C) before choosing the place for
installation. Do not install the unit over another heating device.

Do not power the device on immediately after moving it from a cold place to a warm one and vice
versa. As a general rule, wait for three hours: the device needs this time to adapt to a new environment
(temperature, humidity, etc.).
INSTALLATION
1. Before installation, make sure that all devices to be connected are not powered.
2. Place the bracket base on the supporting surface to mark the 4 fixing holes. Consider the position of
the slot placed on the bracket, used for the passage of the cable (see photo). Use the base as drilling
template.
3. Fix the camera and the provided suitable spanner, taking care to place the cable on the seat present
in the bracket, in order to avoid pinching the cable.
4. Place the bracket in a position suitable for shooting the selected images; the camera can be adjusted
on the HORIZONTAL and VERTICAL axis.
HORIZONTAL AND VERTICAL ADJUSTMENT

Loosen the ring on the bracket and the adjusting screw shown in the figure.

Point the camera at the desired position

Once the adjustment has been performed, tighten the screw with the grub screw and the suitable
spanner
10 DS1092-223