Idiomas disponibles
Idiomas disponibles
Properly leveling your w asher prevents excessive noise and
vibration.
1. Check t helevelness ofthewasher byplacing a level o nthe
topedge ofthewasher, firstside toside, t hen front t o back.
2.
3.
4.
If the washer is against a wall, move the washer out slightly
before tipping back. If the washer is not level, first prop the
front with a wood block and adjust the feet as necessary;
then prop the back and adjust feet as necessary. Repeat this
step until washer is level.
After the washer is level, use a 17 mm open-end wrench to
turn the nuts on the feet tightly against the washer cabinet.
All 4 feet must be tightened.
If the nuts are not tight against
the washer cabinet, the washer may vibrate.
Slide the washer to its final location.
Confirm the levelness of the washer.
1. Check the electrical requirements.
Be sure that you have the
correct electrical supply and the recommended
grounding
method. (See "Electrical Requirements.")
2. Check to be sure all parts are now installed. If there is an
extra part, go back through the steps to see which step was
skipped.
3. Check to be sure you have all of your tools.
4. Dispose/recycle
all packaging materials.
5. Check to be sure the water faucets are on.
6. Check for leaks around faucets and inlet hoses.
Electrica!
Shock
Hazard
Plug
into a grounded
3 prong
outlet.
Do not remove
ground
prong.
Do not use an adapter.
Do not use an extension
cord.
Failure
to follow
these
instructions
can result
in
death,
fire,
or electrica!
shock.
7. Plug into a grounded 3 prong outlet.
8. Read "Washer Use."
g. To test and to clean your washer, measure 1/2 the normal
recommended
amount of powdered or liquid High Efficiency
(HE) detergent. Pour the detergent into the detergent
dispenser. Select NORMAL/CASUAL
and then select START.
Allow the washer to complete one whole cycle.
10
