Husqvarna Z560X Manual De Usuario página 25

CAUTION:
petroleum products to clean drive belts.
Grease nipple
A B
A C
Refer to Lubrication
Lubricate the grease nipple on the
A
pivot axle with a grease gun.
Lubricate the grease nipple on the
B
wheel axle with a grease gun.
Lubricate the grease nipples on
C
each spindle with a grease gun.
Lubricate the grease nipple on the
D
cutting deck idler arm.
Always use good quality grease. Always use
recommended oil, refer to
To lubricate the front wheels
• Remove the dust cap (A). Grease the nipple (B) with
a grease gun until grease comes out from the top
washer.
A
C
Tightening torques
Engine crankshaft bolt
2173 - 002 - 22.08.2023
Do not use gasoline or other
A A
A B
A C
A C
D D
Technical data on page 30 .
B
• Lubricate the joint bearing of the front wheels (C)
with a grease gun until grease comes out.
To lubricate the cutting deck spindles
1. Remove the footrest plate (A).
2. Lubricate the 3 cutting deck spindles (B) 2-3 strokes.
Note:
Use a grease gun with a rubber hose when
you lubricate the cutting deck spindles.
3. Lubricate the idler arm (C) 2-3 strokes.
50 ft-lb / 68 Nm
A
C
B
25