Husqvarna Z560X Manual De Usuario página 21

To remove and install the front wheels
1. Remove the nut and the bolt to remove the front
wheels from the forks.
2. Install in the opposite sequence. Torque the nut and
bolt to 45 ft-lbs / 61 Nm.
To adjust the anti-scalp rollers
The anti-scalp rollers keep the cutting deck in the correct
position on the ground and prevent lawn scalping in
most terrain conditions. The anti-scalp rollers can be set
in 3 positions for different lengths of grass:
• Top position: 1.5–2.5 in. / 38–64 mm grass.
• Middle position: 2.5–4 in. / 64–102 mm grass.
• Bottom position: 4–5 in. / 102–127 mm grass.
1. Park the product on level ground and stop the
engine.
2. Remove the nut, the bolt, the axle and the anti-scalp
roller.
3. Install the anti-scalp roller in one of the 3 positions.
CAUTION:
become damaged if the anti-scalp rollers
are incorrectly adjusted. The anti-scalp
rollers must be approximately 1/4 in. /
6.4 mm from the ground.
2173 - 002 - 22.08.2023
The cutting deck can
To adjust the parallelism of the cutting
deck
This procedure will set the cutting deck in a standard
position.
1. Make sure that the tire pressure is correct. Refer to
Tire pressure on page 20 .
2. Park the product on a level surface.
3. Turn the outer blade tips to align with the cutting
deck side to side.
WARNING:
cutting deck are sharp and can cause
injury. Use protective gloves.
4. Measure the distance between the ground and the
bottom of the blade tip on the discharge side of the
cutting deck. Make a note of the distance.
5. Measure the distance between the ground and the
bottom of the blade tip on the side opposite to the
discharge side. The distance must be the same as
the distance for the discharge side. If adjustment is
necessary, adjust the 2 front bolts until the 2 side to
side distance are equal.
The blades on the
21