Idiomas disponibles
Idiomas disponibles
ENGLISH
Self-emptying base.
Likewise, the self-emptying base includes charging terminals and a signal transmission zone.
Use a clean, dry, soft cloth to wipe dust from these areas.
Changing the dirt-disposal bag. Fig 16:
Open the top cover, remove the bag by carefully pulling it upwards, and replace it with a new
one.
Charging and replacing the battery
-
To extend battery life, leave the robot vacuum cleaner charging on the self-emptying base
whenever not in use.
-
Remove the battery and store it in a safe, dry place if the robot vacuum cleaner will not be
used for a long period of time.
-
To replace the battery, follow the instructions below:
-
Unscrew the screws on the lower housing, remove the latter, and take out the battery.
-
Insert the new battery.
-
Put the battery and the lower housing back in place and re-tighten the screws.
5. TROUBLESHOOTING
Robot vacuum cleaner
Problem
The robot vacuum cleaner does
not switch on or does not clean.
The robot vacuum cleaner isn't
charging or returning to the self-
emptying base.
64
Possible cause and solution
The robot vacuum cleaner does not work when battery
is low. Allow it to charge before operation.
The room temperature is below 0 °C or above 40 °C.
There are too many obstacles near the self-emptying
base. Relocate the base to an obstacle-free area.
Clean the charging terminals of the robot vacuum
cleaner and the self-emptying base.
Make sure the robot vacuum cleaner is switched on.
The robot vacuum cleaner is too far away from the
self-emptying base. Place it closer and try again.
