STERWINS UP20 Instrucciones De Montaje, Utilización Y Mantenimiento página 220

FR
Problems
ES
PT
Machine suddenly
stopped while
cutting branches
IT
EL
PL
Product does not
reach full power
RU
KZ
Vibration or noise
is excessive
UA
Product suddenly
RO
stops
EN
Unsatisfactory
cutting
performance
Probable causes
the Motor maybe occur
overload
the Motor maybe occur
overheat
the Battery maybe occur
overheat
The battery is discharged
Battery pack capacity too
low
Air vents are blocked
Bolts/nuts are loose
The machine has damage
Battery pack discharged
Battery too hot
chain or Guide bar is
worn/ damaged
Chain is rusted
thickness of branches
exceeds capacity
Solutions
Stop the machine and
wait for 3 minutes to
restart.
Stop the machine and
wait for the engine to
cool before switching it
on again.
Stop the machine and
wait for the battery to
cool before switching it
on again.
Charge the battery
according to the
instructions included
with your machine.
Charge the battery
according to the
instructions included
with your machine.
Clean the air vents.
Tighten bolts/nuts.
Do not use the machine
and speack to service
center.
Charge the battery
according to the
instructions included
with your machine.
Turn off the machine
and let it cool down.
Replace the chaine or
the guide bar with a
new one.
Turn off the motor then
clean the Chain or
replace it.
only cut branches
complying with the
capacity.
220
Qualification
-
-
-
Approved repair
centre
-
-