Idiomas disponibles
Idiomas disponibles
Disassembling the Worn Bar and Chain
(Fig . 23)
1. Remove the battery pack, allow the saw to
cool and tighten the oil tank cap.
2. Position the chain saw on its side on a firm,
flat surface, so that the side cover is facing
upwards.
3. Wear gloves. Remove the side
cover by turning the side-cover knob
counterclockwise. Clean the side cover
with a dry cloth.
4. Remove the bar and chain from the
mounting surface. Remove the worn chain
from the bar.
This is a good time to inspect
NOTICE
the drive sprocket for excessive wear or damage.
Assembling the New Bar and Chain
1. Lay the new saw chain in a loop on a flat surface and straighten any kinks (Fig. 24).
2. Place the chain drive links into the guide bar groove. Position the chain so there is a loop
at the back of the guide bar (Fig. 25).
3. Hold the chain in position on the guide bar and place the loop around the sprocket of the
power head.
Fig . 24
Small directional arrows are engraved in the saw chain (Fig. 26a). Another
NOTICE
directional arrow is molded into the housing (Fig. 26a). When looping the saw
chain onto the sprocket, make sure that the direction of the arrows on the saw chain will
correspond to the direction of the arrow on the housing. If they face in opposite directions, turn
over the saw chain and guide bar assembly (Fig. 26b).
28
Fig . 23
Fig . 25
Chain Drive
Links
Guide Bar
Groove
