Idiomas disponibles
Idiomas disponibles
CUT COUNTERTOP OPENMNG
CHANGING
BLOWER
DmSCHARGE (Optionam)
The blower
is shipped
with its discharge
facing
DOWN.
Follow
these steps ONLY
if:
,, the position
of the blower
discharge
needs to be moved
so ductwork
does
not interfere
with floor joists,
plumb
ing or wiring
below.
,, it is necessary
to rotate the blower
discharge
to the
RIGHT
or LEFT.
Place
the unit on its back on a table or work surface.
1.
2.
Lay out and cut the cooktop
cut=out far enough
FORWARD
so
downdraft
will fit behind
it.
Set cooktop
in place and slide
it as far forward
as possible.
Center
and square
it with edges
of countertop.
DOWN
DISCHARGE
o MOVING
BLOWER
LEFT OR RIGHT
SHEET
BLOWER
METAL'_
NUTS
SCREW
CLAMP
CHANNEL'_
BOTTOM
FLANGE
1. Loosen
the 4 nuts and 2 clamp
channels.
2.
Slide blower
to desired
position.
3.
Use supplied
cover
plate to close
open space
(if any).
4.
Tighten
wing nuts to secure
top of blower
and use sheet metal
screws
through
bottom
flange
to secure
bottom
of blower.
LEFT
OR RBGHT DISCHARGE
3.
Place
the plastic
template
against
the back
flange
of the
cooktop
and center
it. Trace
around
template
to mark
the
downdraft
opening.
4.
Remove
cooktop
from countertop.
5. Cut
downdraft
opening.
Be
careful
not to chip
edges
of
countertop.
MOUNT THE UNtT
MOUNTING
SCREWS
NUT
LEVELING
BRACKET-
FLANGE
FACING OUT
LEVELING
BRACKET
-
FLANGE
FACING IN
1. Remove
the 4 nuts and 2 clamp
channels.
2.
Carefully
lift blower
and disconnect
motor plug if necessary.
Reposition
blower
and RECONNECT
MOTOR
PLUG.
3.
Use supplied
cover
plate to close
open space
(if any).
4.
Replace
clamp channels
and use nuts to secure
the blower
in
its new position.
5.
Use sheet
metal
screws
through
bottom
flange
to secure
bottom
of blower.
1. Set downdraft
into opening.
Extend
leveling
brackets
to floor
of cabinet
so downdraft
sits straight.
(Note:
Leveling
brackets
can be removed
and re-attached
in other
positions.
Bottom
flange
may have to face inward
in tight cabinet
installations.)
2. Secure
the downdraft
to the countertop
as follows:
Hold the
downdraft
against
the back of countertop
cut-out
and tighten-
ing the 2 mounting
screws
(one
on each
end of unit)
on
underside
of countertop.
Use a wood shim between
screw and
underside
of granite
countertops.
3. Screw
leveling
brackets
to bottom
of cabinet.
Tighten
screws
3
holding
leveling
bracket
to unit on each side.
