TERMA VEO SMART WI-FI Manual página 6

ELECTRIC HEATING ELEMENT
SAFETY REQUIREMENTS — INSTALLATION
1. Fitting and connection of the heating element should only be performed
by a qualified installer.
2. Connect the unit to a sound electrical installation (see the ratings on
the heater).
3. Switching on the heating element in the open air to test the device is
permitted for a maximum of 3 seconds.
4. Never test a heating element that is already installed. Do not turn the
heating element on in an empty radiator!
5. Ensure that the power cord does not touch the hot parts of the heat-
ing element or radiator.
6. Before installing or removing the device, make sure it is disconnected
from the power source.
7. Do not open the device — any interference with internal components
will invalidate the warranty.
8. The heating element's power output should not exceed the radiators
power output for the parameters 75/65/20° C.
9. The pressure in the radiator must not exceed 1 MPa (10 bar). Ensure
that an air cushion is preserved in electric radiators. In central heating
systems, leave one valve open to prevent pressure build up due to the
thermal expansion of the liquid.
10. Fitting and Installation of the device must be carried out in accordance
with all local regulations for electrical safety, including installa tion within
permissible locations only. Observe bathroom electrical zone regulations.
11. The device is intended for home use only.
6