TERMA VEO SMART WI-FI Manual página 15

HEATING ELEMENT OPERATION VIA THE INTERFACE PANEL
LED strips
control keys
White stripes 5 stripes 26°C
4 strips 24°C
3 strips 21°C
2 strips 18°C
1 strip 15°C
Red stripe DRYER function is on
1. To wake up the device from the sleep mode, briefly press any button.
2. To raise or lower the temperature by one step, briefly press + or − button.
3. To start the DRYER function, press and hold the + button — a red stripe
will appear on the interface, and the heating element will start to heat
Red stripe
15
EN
at 80% of the rated power for the duration of 1 hour. Then the element
will return to the previous settings.
4. To swap the + and −, buttons, press and hold (> 10 s) the + button.
5. Modes and special actions — press and hold both + and − buttons
simultaneously:
a. for 5 s — the heating element turns off (single flash on the interface);
b. for 10 s — the heating element will be put to sleep (stand-by mode)
(single flash on the interface);
c. for 15 s — enter pairing mode (AP) all interface will flash 3 times;
d. for 25 s — restore factory settings and start the pairing mode, the de-
vice will flash as it did at set-up;
6. If the heating element's controller panel has been blocked (the PAREN-
TAL CONTROL function in the control application), pressing the + key
for 5 seconds will release the lock for 1 minute, which will allow you to
change the settings manually on the device without the need to use
the application (confirmation by flashing interface).
The change made on the device manually is valid until the next automatic
temperature change saved in the schedule.