Makita DFL651F Manual De Instrucciones página 8

Function
Check the LED indi-
cator, light and beeper
operation
Anti-reset of controller
Overheat
Operation error of the
switch trigger
Motor failure
Double-hitting detection
Maintenance alarm
Tool in connection with
PC (no data communica-
tion started/communica-
tion unavailable)
Tool in connection with
PC (data communication
started)
Adjusting the fastening torque
2
1
► 1 . Screw 2. Ring 3. Clutch case
Status
This function works to Lights up first in green,
check the proper opera- next red.
tion of the LED indicator, (And then the light
light and beeper when a comes on.)
battery cartridge has been
inserted into the tool.
This function works Flickers in red and green
when an abnormal drop alternatively.
of the battery voltage
occurs for some reason,
and the tool stops.
This function works when Flickers in red quickly.
the temperature of the
controller goes up very
highly, and the tool stops.
This function works to Flickers in red and green
avoid the tool's immedi- alternatively.
ate start upon insertion
of battery cartridge into
the tool with the switch
trigger being pulled.
Motor failure has been Flickers in red and green
detected. At this time, alternatively.
tool does not work.
This function works Lights up in red.
when a screw is refas-
tened after fastening.
This function shows the Flickers in yellow.
maintenance time has come
according to your preset
number of screws driven.
This function shows data Flickers in yellow.
cannot be exchanged
between the tool and
PC in spite of the
connection.
This function shows the Flickers in green.
tool is connected to PC and
data exchange between the
tool and PC can be done in
normal conditions.
3
Status of the LED indicator/beeper
LED indicator
A series of very short
beeps
A series of short beeps
A series of short beeps
A series of short beeps
A series of short beeps
A long beep
1
► 1 . Scale 2. Hole for adjusting grip 3. Yellow line
When you wish to drive machine screws, wood screws,
hex bolts, etc. with the predetermined torque, adjust the
fastening torque as follows.
1. First remove the battery cartridge from the tool.
2. Remove the protector from the clutch case.
3. Loosen and remove the screw that secures ring.
4. Rotate the ring on the tool by hand so that a hole
can be seen below the ring.
8 ENGLISH
Action to be taken
Beeper
Replace the battery with
fully charged one.
Remove the battery car-
tridge immediately and
cool the tool down.
Release the switch
trigger.
Ask your local Makita
Service Center for repair.
– Reset the alarm with the
application software.
– Restart the application
software and re-connect
the USB cable.
–
–
–
–
2
3