Craftsman 358.792410 Manual De Instrucciones página 7

INSTALLING
ATTACHMENT
1. Remove the shaft cap from the at-
tachment (if present) and discard.
2= Position locking/release button of
attachment into guide recess of up-
per shaft coupler.
3= Push the attachment into the cou-
pler until the locking/release button
snaps into the primary hole.
4= Before using the unit, tighten the
knob securely by turning clockwise.
couple r Primary Hole
Guide Recess
Upper Locking/ Attachment
Shaft Release
Button
,_WARNING: Make sure the lock-
ing/release button is locked in the pri-
mary hole and the knob is securely
tightened before operating the unit.
Using the wrong hole could lead to
serious injury or damage to the unit.
Secondary Hole
OPERATING POSITION
ALWAYS WEAR:
i Eye Protection
Long Pants
Heavy Shoes
,_WARNING: To avoid personal
injury, never carry the cultivator while
the unit is running.
,,_WARNING: The gearbox gets
very hot after extended periods of use.
To avoid burns, do not touch the gear-
box until it has been allowed to cool.
CULTIVATING
1= Move the cultivator to the work area
prior to starting the engine/motor.
2. With the engine/motor running and
the tines off the ground, press the
throttle trigger to increase the en-
gine speed.
3. Hold trigger handle and assist han-
dle firmly. Slowly lower the cultiva-
tor until the tines make contact with
the ground.
Locking/Release
Button in Primary Hole
INSTALLING ATTACHMENT
HANGER
An attachment hanger is provided for
storage when attachment is not in
use.
To install hanger on attachment:
1= Remove the shaft cap from the at-
tachment (if present) and discard.
2= Press and hold the locking/release
button.
3= Push hanger onto the attachment
until the locking/release button
snaps into the hole.
4. As unit begins cultivating, pull back
on the unit so that the tines can
penetrate the ground.