Idiomas disponibles
Idiomas disponibles
METALWATERPIPEGROUNDING
IMPORTANT:
This Central
Water
Whole
Home Filter
has a non-metallic
valve system.
Installing
it on metal
plumbing
will break
electrical
continuity,
which may interrupt
grounding
for the home.
You must restore
electrical
continuity
in your metal
plumb-
ing system.
If you installed
a 3-valve
bypass system (Fig. 7), electri-
cal continuity
will be maintained.
If you installed
the
non-metallic
bypass valve (Fig. 8), restore the ground
as
follows:
Install a #4 copper
wire (parts not included)
across the
removed
section of metal
water
pipe, securely clamping
it at both ends (See Fig. 9).
Be sure the pipes are clean
under the clamps,
to assure good contact.
NOTE:
If you are installing
a water
softener
or other
item(s) into the plumbing
system, along
with the
Central
Water
Whoel
Home Filter, be sure to
restore electrical
continuity
across all removed
metal
pipe sections.
INSTALL VALVE DRAIN
HOSE
1. Measure,
cut to needed length and connect
the 3/8"
drain line (provided)
to the Central
Water
Whole
Home Filtration
System valve drain fitting
(See Figure
10). Use a hose clamp
to hold the hose in place.
NOTE: If codes require
a rigid drain line see "Valve
Drain requirements"
section.
2. Run the drain
hose or copper
tubing to the floor
drain.
Secure drain
hose.
This will prevent the drain
line from "whipping"
during
Clean Rinse cycles.
See
"Air Gap
Requirements"
section.
METAL
PIPE GROUNDING
(parts not included)
Ground
Wire
/
Figure 9
Drain Line
Connection
SINGLE
BYPASS VALVE
Pull handle
OUT for normal
I
Push handle
IN
I
for BYPASS
Figure 10
Questions?
Call The Kenmore
Water
Line 1-800-426-9345
or visit KenmoreWater.com
10
