Idiomas disponibles
Idiomas disponibles
RESETTING
TO FACTORY
DEFAULTS
To reset the electronic
controller
to its factory
default
for all settings (time, frequency
of automatic
Clean
Rinse cycles, etc.):
1. Press the SELECT button and hold it until the display
changes
twice to show "SET CODE"
and the flashing
model code.
2. Press the /X UP button
twice to display
a flashing
"SOS".
3. Press the SELECT button,
and the electronic
controller
will restart.
4. Set the present time, as described
on page 12.
SET
CODE
dF
SET
CODE
Figure 22
CLEANING
THE DRAIN
FLOW CONTROL
This procedure
is not required
if the Central
Water
Whole
Home Filtration
System is operating
normally.
It
should be performed
only if a problem
with lack of
water
flow to drain is encountered,
as detailed
in the
troubleshooting
table
on Page 19.
1. Remove the clip holding
the drain fitting
into the
valve (See Figure 23).
2. Remove the drain fitting
from the valve
3. Clear any obstruction.
4. Reinstall the drain fitting
into the valve.
5. Reinstall the clip to secure the drain fitting
in the
valve.
Drain
Hose
REMOVING
DRAIN
FITTING
TO CLEAN
FLOW CONTROL
Flow
Clip
Control
Clamp
f
Drain
Fitting
j_
Figure 23
Questions?
Call The Kenmore
Water
Line 1-800-426-9345
or visit KenmoreWater.com
21
