Idiomas disponibles
Idiomas disponibles
Maintenance
FUELING
Gasoline
1. Open fill pipe cap located on chassis left side
(see figure 7).
2. Fill to capacity with unleaded motor fuel only.
3. Check fuel level by lifting flap located on top of chassis
left side (see figure 7). Fuel tank full capacity is 94l [25
US gallons].
Diesel
1. Open fill pipe cap located on chassis left side
(see figure 7).
2. Fill to capacity with diesel motor fuel only,
grade #1-D, or #2-D. Use distillate fuel only, do not
use residual or blend.
3. Check fuel level by lifting flap located on top of chassis
left side (see figure 7). Fuel tank full capacity is 94l [25
US gallons].
HYDRAULIC OIL
1. Check oil level at sight gauge inside engine compart-
ment right hand side with the platform fully lowered.
2. If necessary, fill to capacity with clean ISO 46 compat-
ible hydraulic oil.
3. Lift flap located on top of chassis right side (see
figure 7).
4. Open filler / breather cap to add hydraulic oil.
5. Replace cap.
LUBRICATION
Refer to service manual for lubrication chart and
guidelines.
Fuel Fill Pipe
Figure 7: Fuel Fill Pipe and Level Gauge
BATTERY MAINTENANCE
Check battery fluid level daily, especially if work platform
is being used in a warm, dry climate.
If electrolyte level is lower than 10 mm (
plates add distilled water only. DO NOT use tap water it
will shorten battery life.
Keep terminals and top of battery clean.
TIRES
Tire selection can affect the stability of the machine. Use
only tires supplied by UpRight unless approved by the
manufacturer in writing.
Fuel Level Gauge
9
Hazard of explosive gas mixture. Keep sparks,
flame and smoking materials away from batteries.
Always wear safety glasses when working with
batteries.
Battery fluid is highly corrosive. Rinse away any
spilled fluid thoroughly with clean water.
Always replace batteries with UpRight batteries or
manufacturer approved replacements weighing
62 lbs. each.
Hydraulic Oil Filler / Breather Cap
Figure 8: Hydraulic Oil Filler / Breather Cap
3
/
in.) above
8
