GE PGP990 Manual Del Usuario página 26

Installation Instructions
INSTALL THE COOKTOP
PREPARE THE COOKTOP
Remove the vent grille, vent filter, sealed burner
module and the tape from the burner caps.
Turn the cooktop over (upside down) and gently
place it on the styrofoam packing.
Unscrew (loosen) the side hold-down screws.
Use styrofoam Loosen side
to protect cookto t hold-down screws
Install the plenum to the cooktop using 4 screws.
The motor opening on the box goes toward the left
side of the unit (the side with the grease jar lid).
[] PREPARE THE COOKTOP (cont.)
Rotate the cooktop and plenum forward and
carefully set it on its back edge on the styrofoam
packing.
Install the blower assembly onto the plenum so
that the blower exhaust is pointing down or back
as needed. Push the bolts through the bolt holes
in the plenum.
Forbeck exhaust,
position blower outlet
in direction of this
arrow
For down
exhoust, position
blower outlet in
direction of this
arrow
From the vent opening in the top of the cooktop,
install the vent guard over the bolts. Use the 4 nuts
to secure the blower assembly and vent guard to
the inside of the plenum.
4 Nuts
(3/8" socket
required)
Vent guard
26