GE PGP990 Manual Del Usuario página 32

LP Conversion Instructions
121 CONVERT SURFACE BURNERS
Turn clockwise to tighten
Orifice
Turn counterclockwise to remove
[] Remove all grates and burner modules.
[] With an adjustable wrench or an open end wrench,
remove the brass orifices.
[] Find the inscribed LPorifices in the holder in the front
of the electric cover beneath the cooktop.
[] Install the inscribed LPorifices in place of the natural
gas orifices.
[] Replace the burner modules and grates.
[] Keep all the spuds with your cooktop so you have
them if you move or get a different gas hook-up.
LP (Propane) Gas 10" W.C.R
Burner Output Rating in BTU/HR
Location BTUs Orifice Size Engraving
Left Rear (LR) 9,100 .0354 LP
Left Front (LF) 9,100 .0354 LP
Right Rear (RR) 9,100 .0354 LP
Right Front (RF) 9,100 .0354 LP
1-31 A DJUST GRILL BURNER AIR SHUTTER
oosen screw
TAilt_ttnO irc_he utt er opening
The air shutters for the grill burner may need to be
adjusted to get better flame appearance and ignition.
The air shutters for the grill burner are located on
the bottom of the grill burner. To access the air shutters,
remove the grill grate, and then the grill burner. Loosen
the screw and slide the air shutter backward or forward
to increase or decrease the size of the air opening.
Re-tighten the screw.
[] CHECK IGNITION
[] Connect electrical supply cord.
[] Turn on the gas; check for leaks using a liquid leak
detector at all joints in the system.
WARNING: DO NOT USE A FLAME
TO CHECK FOR GAS LEAKS.
[]
Push in one control knob
and turn to the LITEposition.
The igniter will spark and the
burner will light. The first test
may require some time while air
is flushed out of the gas line.After
ignition, turn the control knob to
the HI position and wait until the flame settles.
Check to determine if your burner flames are normal.
If burner flames look like A, turn off the burner and
make sure all parts are assembled correctly.
Reassemble and check.
Normal burner flames should look like B or C,
depending on the type of gas you use. With LP gas,
some yellow tipping on outer cones is normal.
A-Yellow flames B-Yellow tips C-Soft blue flames
Not normal; Normal for Normal for
check LPgas natural gas
alignments
[] Turn the knob to OFF.
[] Repeat the procedure for each burner.
32