Idiomas disponibles
Idiomas disponibles
AIR CONDITIONER
FEATURES
The controls featured in this manual are
representative of the many models available. Your
model may look slightly different.
,
OFF
3e
4e
16 e7
HIG_
FAN •
LOW
FAN
2•
e8
TEMP
MODE
HIGH
Y
LOW
°COOL
TEMP
The thermostat will automatically control the
temperature of the room, Select a higher number for
lower room temperature, The temperature is
selected by turning the TEMP knob to the desired
position.
The 5 or 6 position is a normal setting for average
conditions.
MODE
OFF :
HIGH FAN :
LOW FAN :
Turns the air conditioner off.
Permits the high fan speed
operation without cooling.
Permits the low fan speed operation
without cooling.
HIGH COOL : Permits cooling with the high fan
speed operation.
LOW COOL :
Permits cooling with the low fan
speed operation.
VENT CONTROL
The Vent Control allows the air conditioner to either
recirculate inside air (CLOSE) or exhaust air to the
outside (OPEN).
• The CLOSE position is used when maximum
cooling is desired. It may also be used for air
recirculation without cooling when the air
conditioner is set in the FAN position.
• The OPEN position removes stale air from the
room and exhausts it to the outside. Fresh air is
drawn into the room through normal air passages
found in homes.
• The OPEN or CLOSE position can be used with
any fan selection.
PULL OPEN / PUSH CLOSE
VERTICAL AIR DIRECTION CONTROL
The vertical air direction is adjusted by moving the
louver upward or downward.
DRAINAGE
First, be sure to insert the drain pipe into base pan
before installation.
The air conditioner must be installed with a slight tilt
to the outside for proper water drainage. The air
conditioner will drain the excess condensed water
through the drain pipe.
DRAIN_R
\
BASEPANBOTTOM
-11 -
