Hilti SL 2-A12 Manual De Instrucciones Original página 13

▶ Store the product and the batteries in a cool and dry place. Comply with
the temperature limits stated in the technical data.
▶ Do not store batteries on the charger. Always remove the battery from
the charger when the charging operation has completed.
▶ Never leave batteries in direct sunlight, on sources of heat, or behind
glass.
▶ Store the product and batteries where they cannot be accessed by
children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the
product and the batteries for damage.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, please contact Hilti Service.
8.1 Troubleshooting
Trouble or fault
The battery does
not engage with an
audible double click.
1 LED flashes.
The power tool does
not work.
9 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping
gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical
tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local gov-
ernmental garbage disposal or public health and safety resources for
disposal instructions.
Most of the materials from which Hilti products are manufactured can
be recycled. The materials must be correctly separated before they can
*2171356*
Possible cause
The retaining lugs on the
battery are dirty.
Battery is discharged.
The battery is too hot or
too cold.
2171356
Action to be taken
▶ Clean the retaining
lugs and push the
battery in until it
engages.
▶ Change the battery
and charge the empty
battery.
▶ Allow the battery to
cool down or warm
up slowly to room
temperature.
English 9