Tabla de contenido
Idiomas disponibles
Idiomas disponibles
NOTE:
Only one device can be assigned to an unused
device key at a time.
To Re-Assign
AUX as 2nd
AUXÆSETUPÆ9Æ9Æ2ÆAUDÆAUX
AUD key
AUXÆSETUPÆ9Æ9Æ2ÆTVÆAUX
AUX as 2nd
TV key
AUX as 2nd
AUXÆSETUPÆ9Æ9Æ2ÆCBLÆAUX
CBL key
AUXÆSETUPÆ9Æ9Æ2ÆAUXÆAUX
AUX back to
AUX
To re-assign another unused device key, substitute it for
the AUX key above and then perform the sequence. For
example, to re-assign an unused AUD key as a second
DVD key, perform
AUDÆSETUPÆ9Æ9ÆÆDVDÆAUD.
When a re-assignment is done, the selected device key
(e.g., AUD) will blink twice to confirm your choice. At
that time, you will need to program device control (see
"Programming Device Control" on page 8).
CLEARING CUSTOM PROGRAMMING
The Atlas DVR/PVR 5-Device Universal Remote Control
with Learning contains a Custom Programming Reset
program. You can use it to remove all custom
programming, except your setup codes and reassigned
device keys.
IMPORTANT: Executing this program will erase all cus-
tom settings for Volume Lock, Learned Keys,
Tune-In Keys, and Channel Lock. However,
your device programming remains.
1.
On the remote control, press and hold SETUP
until the last-selected device key blinks twice.
2.
Enter 9 8 0. The last-selected device key
blinks twice, pauses, and blinks twice again to
confirm that all custom programming is
cleared.
TROUBLESHOOTING
PROBLEM: Device key does not blink when you press a
key.
SOLUTION: Replace the batteries with two (2) new AA
alkaline batteries (see "Installing Batteries" on page 8).
www.urcsupport.com
Perform Key Sequence
22
Capítulos
Tabla de contenido
