Programming Device Control - Universal Electronics ATLAS XL Guia Del Usuario

PROGRAMMING DEVICE CONTROL

The Atlas XL Universal Remote Control is preprogrammed
to operate the cable converter provided by your cable
service provider, an RCA TV, an RCA VCR, and a Pioneer
audio receiver.
To control devices other than the default brands, perform
the following steps; otherwise skip this section:
NOTES: To control a DVD player, program the VCR key. To control
a PVR, program the VCR key. To control a stereo amplifier or
receiver, program the AUD key. For TV/VCR Combo control, skip
this section and perform the instructions on page 10.
1.
2.
3.
4.
Turn on a device and, if applicable, insert
video media, (e.g., cassette or disc).
NOTE: Please read steps 2 through 4 completely
before proceeding. Highlight or write down the codes
and device you wish to program before moving on to
step 2.
On the remote control, press a device key once
(e.g., AUD, VCR, or TV). Press and hold
SETUP until the selected mode key blinks
twice, then release SETUP.
Use the Manufacturer's Codes (starting on
page 42) to locate the the type of device and
brand name and then enter the first four-digit
code for your device. If performed correctly,
the selected mode key will blink twice.
NOTE: If the selected mode key emits a long blink,
the entry is invalid. Repeat steps 2 through 3 and try
entering the same code again.
Aim the remote control at the device and
press POWER once. The device should turn
off. If it does not, repeat steps 2 through 3,
trying each code for your brand until you
find one that works. If it still does not
respond, try searching for the code (see
Searching For Your Code on page 11).
NOTE: If the device does not have a POWER key,
press the (Play) key.
8