Idiomas disponibles
Idiomas disponibles
- Make sure the contact tip and the liner are compatible with the diameter of
the weld wire and the grooved pulley feeding.
- Observing the position of the connections, set the torch in an appropriate
position. Tighten the euro connector nut to ensure good contact.
WARNING: The torch trigger should not be fed above 25 VAC or 60 VDC.
- Remove the contact tip, insert the wire in the torch, place the contact tip
back in its place, and cut the excess wire.
- Adjust the gas fl ow using the fl ow meter.
- Be sure there is adequate water fl ow before using the water-cooled torches.
- Clean and degrease the pieces that are to be welded; protect the point to
be welded from contamination.
- Keep the point to be welded away from air currents.
- Place the earth clamp on the part to be welded or the gauge, while ensuring
there are good conditions for electrical contact.
- Adjust the welding parameters checking the recommended duty cycles for
each of Sumig's torch models mentioned in the replacement parts brochure
attached.
The liners are identifi ed according to the terminal the following colors:
Gauge
Pt
Pt
0,6 - 0,8
0,8 - 1,0
1,2
En
1,2 - 1,6
1,6 - 2,4
Es
0,8 - 2,4
Before Using the MIG/MAG Guns
Color
Guns
Grey
SU 220 / SU 260 / SU 265
Black
SU 335/SU 535/SU 595/SU 930/SU 931/SU 365/SU 565
Yellow
SU 335 / SU 931 / SU 365
Blue
SU 535 / SU 595 /SU 695 / SU 930 / SU 565
Red
SU 695
without
SU 735 / SU 932 / SU 933 / SU 765
covering
08
